Test Suspension brew check

[TractionIssues]

I'm new to homebrew, and I wanted to start with Test Suspension since I love it and it's very cheap, so if I screw it up, it's no big deal. I would like to brew my gear this way, and would like to know if everything looks good before I start.

100ml @ 100mg/ml
10g Test Base
58ml Bacteriorstatic Water
2ml BA
15ml BB
15ml EO

I would put all the ingredients in a 250ml Beaker, heat on a pan on the stove at med for 15 minutes, until it is all dissolved while stirring it slightly. Then while it is all dissolved and on low heat, I would pull it out with a .45 whatman filter, 10 or 20ml at a time (some people say 1 ml at a time but that would take forever @ 100ml?) and send it directly into a sterile sealed 100ml vial.

Does this look good, or does anyone think a different ratio or different solvents would make this more stable/less painful? All advice is appreciated, this will be my first time. Also, would this be okay to shoot this in the same syringe with my bac water gh?

[leigh]

that should work, I don't see why not.

You could probablly get away with using just, ba, bb and some sort of oil.

[TractionIssues]

Thanks, if I was to put an oil, would it be the same process and results? Would it still pass through a slin pin?

[leigh]

same process, add bb and ba to powder, give a little heat till clear, add oil, heat to required temp and then filter.

For a slin pin, I would go with a thin oil, maybe grape seed. Can I ask why are you using slin pins, don't like the bigger gauge?

[ApC]

im trying to make boldenone suspension did this method work for u bro